.jpg)
EV conversion 1955 MG ZA Magnette by Kustom Bitz
Kustom Bitz is doing an EV conversion on this 1955 MG ZA Magnette. The job is a complete restoration and driveline conversion, it doen't look much at the moment but we have been pulling it apart to completely strip the paint for a full rotiserie restoration on the body. The sills need replacing and the rear guards need some rust repairs but apart from that the body is mint.
You can follow the restoration on https://www.facebook.com/MGEVMagnette
We will be installing an air cooled Hyper9 AC motor and controller with two LFP battery packs, one in the boot and one in the front engine bay. The electric motor will sit in the gearbox tunnel with a Torque Trends USA Long tail housing reduction box, with integral park lock, like an auto trans has.
The base EV technology that is going into this car has been around since the 1990s and I have been selecting, repairing and working on IGBT drive technolgy in the automation industry since that time, so combining my restoration skills and EV technology make sense to me.
Intended as a city run around it should be a pretty stout combination as the Hyper9 puts out a similar torque to a stock 289 Windsor but from zero rpm all the way up. Rated at approx 200hp. The body is light weight at just on 1080kg stock, weight gets pulled out, engine and gear box [all cast iron], and the batteries is similar in weight so ends up around the same once finished.
You can follow the restoration on https://www.facebook.com/MGEVMagnette
We will be installing an air cooled Hyper9 AC motor and controller with two LFP battery packs, one in the boot and one in the front engine bay. The electric motor will sit in the gearbox tunnel with a Torque Trends USA Long tail housing reduction box, with integral park lock, like an auto trans has.
The base EV technology that is going into this car has been around since the 1990s and I have been selecting, repairing and working on IGBT drive technolgy in the automation industry since that time, so combining my restoration skills and EV technology make sense to me.
Intended as a city run around it should be a pretty stout combination as the Hyper9 puts out a similar torque to a stock 289 Windsor but from zero rpm all the way up. Rated at approx 200hp. The body is light weight at just on 1080kg stock, weight gets pulled out, engine and gear box [all cast iron], and the batteries is similar in weight so ends up around the same once finished.
.jpg)
Comment(s)0